Datalogic QuickScan QD24 series - I 2 of 5 Set Length 1

Enter/Exit Programming Mode Interleaved 2 of 5 (I 2 of 5)
132 QuickScan™ I QD24XX/QBT24XX/QM24XX
I 2 of 5 Set Length 1
This feature specifies one of the bar code lengths for I 2 of 5 Length Control on page 131.
Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length if in
Fixed Length Mo
de. The length includes the bar code’s check and data characters. The length
can be set from 2 to 50 characters in increments of two.
Table 7 provides some examples for setting Length 1. See page 243 for detailed instructions on
setting this feature.
Table 7. I 2 of 5 Length 1 Setting Examples
STEP ACTION EXAMPLES
1 Desired Setting
2 Characters 6 Characters 14 Characters 50 Characters
2
Pad with leading zeroes to
yield two digits
02 06 14 50
3 Scan ENTER/EXIT PROGRAMMING MODE
4 Scan SELECT I 2 of 5 LENGTH 1 SETTING
5
Scan Two Characters From
Appendix D, Keypad
‘0’ and ‘2’ ‘0’ and ‘6’ ‘1’ and ‘4’ ‘5’ AND ‘0’
6 Scan ENTER/EXIT PROGRAMMING MODE
$CI2L1
Select I 2 of 5 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
06 = Length 1 is 6 Characters