Datalogic QuickScan QD24 series - Send Batch; Erase Batch Memory; RF Batch Mode Transmit Delay

WIRELESS FEATURES Enter/Exit Programming Mode
Product Reference Guide 219
Send Batch
When the scanner is configured in Manual Batch Mode, use the following bar code to initiate
sending of labels stored in batch memory.
BatchSend
Send Batch
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunction with this bar
code.
Erase Batch Memory
When the scanner is configured in Manual Batch Mode, use the following bar code to erase any
labels stored in batch memory.
BatchClear
Erase Batch Memory
Do not scan an ENTER/EXIT PROGRAMMING MODE label in conjunction with this bar
code.
RF Batch Mode Transmit Delay
Specifies the delay in 10 msec increments between transmitting labels stored in batch memory.
DEFAULT
$CBTTD00(CR)
RF Batch Mode Transmit Delay = No Delay
$CBTTD05(CR)
RF Batch Mode Transmit Delay = 50 mS
$CBTTD0A(CR)
RF Batch Mode Transmit Delay = 100 mS