Symbology Selection Enter/Exit Programming Mode
Product Reference Guide
183
Aztec Code Set Length 1
Specifies one of the bar code lengths for Aztec Code Length Control on page 182. Length 1 is
the minimum label length if in Vari
able Length Mode, or the first fixed length if in Fixed Length
Mode. Characters can be set from 0001 to 3,832 characters in increments of 0001 (pad with
zeroes).
See page 243 for detailed instructions on setting this feature.
Select Aztec Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by
scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
0001 = Length 1 is 1 Character
To Next Page
Loading...
