Datalogic QuickScan QD24 series User Manual

RS-232/USB-Com Interfaces Enter/Exit Programming Mode
Product Reference Guide 35
ACK Character
This setting specifies an ASCII character or hex value to be used as the ACK character. ASCII
characters or any hex value from 0 to 0xFF can be selected. See page 234 for more info
rmation.
$CR2AC
Select ACK Character Setting
DEFAULT
0x06 ‘ACK’ Character
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
on page 29
has been set as 7 Data Bits.
NAK Character
This setting specifies an ASCII character or hex value to be used as the NAK character. ASCII
characters or any hex value from 0 to 0xFF can be selected.
Setting to previously defined characters such as XON, XOFF, or host commands conflicts with
normal operation of these characters. 8-bit data is not recognized when the option
Data Bits
on page 29 has been set as 7 Data Bits.
See page 235 for more information.
$CR2NA
Select NAK Character Setting
DEFAULT
0x15 ‘NAK’ Character

Datalogic QuickScan QD24 series Specifications

General

Brand	Datalogic
Model	QuickScan QD24 series
Category	Barcode Reader
Language	English