Datalogic QuickScan QD24 series - Maxicode Length Control; Maxicode Set Length 1

Enter/Exit Programming Mode
192 QuickScan™ I QD24XX/QBT24XX/QM24XX
Maxicode Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbol-
ogy.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
$CMXLC00(CR)
Maxicode Length Control = Variable Length
$CMXLC01(CR)
Maxicode Length Control = Fixed Length
Maxicode Set Length 1
Specifies one of the bar code lengths for Maxicode Length Control on page 192. Length 1 is the
minimum label length if in Varia
ble Length Mode, or the first fixed length if in Fixed Length
Mode. Characters can be set from 0001 to 0145 characters in increments of 0001 (pad with
zeroes).
See page 243 for detailed instructions on setting this feature.
$CMXL1
Select Maxicode Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by
scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character