Datalogic QuickScan QD24 series - China Sensible Code Set Length 1

Enter/Exit Programming Mode
186 QuickScan™ I QD24XX/QBT24XX/QM24XX
China Sensible Code Set Length 1
Specifies one of the bar code lengths for China Sensible Code Length Control on page 185.
Length 1 is the minimum l
abel length if in Variable Length Mode, or the first fixed length if in
Fixed Length Mode. Characters can be set from 0001 to 7,827 characters in increments of 0001
(pad with zeroes).
See page 243 for detailed instructions on setting this feature.
$CCSL1
Select China Sensible Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by
scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character