Datalogic QuickScan QD24 series - BT PIN Code; Select PIN Code Length; Set PIN Code

Enter/Exit Programming Mode BT Security Features
224 QuickScan™ I QD24XX/QBT24XX/QM24XX
BT PIN Code
After enabling Security Mode (see "BT Security Mode" on page 223), specify whether you want to
set a 4-digit or a 16-digit PIN Code. See page 264 for detailed information and examples for
setting this feature.
$CBTPS00\r
Select 4-character BT PIN Code
DEFAULT
~$CBTPS01\r
Select 16-character BT PIN Code
Select PIN Code Length
Set PIN Code
Determine the desired characters for the PIN code, then convert to hexadecimal using the ASCII
Chart on page 1 on the inside back cover of this manual. See page 264 for detailed information
and examples for settin
g thi
s feature.
$CBTPC
Set 4-character BT PIN Code
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D Keypad representing
your desired character(s). End by
scanning the ENTER/
EXIT bar code again.
$CBTP6
Set 16-character BT PIN Code
~
CANCEL
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
DEFAULT
31323334 = Default PIN Code is 1234