Datalogic QuickScan QD24 series - Data Matrix Length Control; Data Matrix Set Length 1

Symbology Selection Enter/Exit Programming Mode
Product Reference Guide 189
Data Matrix Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbol-
ogy.
Variable Length: For variable length decoding, a minimum and maximum length may be set.
Fixed Length: For fixed length decoding, two different lengths may be set.
DEFAULT
$CDMLC00(CR)
Data Matrix Length Control = Variable Length
$CDMLC01(CR)
Data Matrix Length Control = Fixed Length
Data Matrix Set Length 1
Specifies one of the bar code lengths for Data Matrix Length Control on page 189. Length 1 is
the minimum label length if in Vari
able Length Mode, or the first fixed length if in Fixed Length
Mode. Characters can be set from 0001 to 3,116 characters in increments of 0001 (pad with
zeroes).
See page 243 for detailed instructions on setting this feature.
$CDML1
Select Data Matrix Length 1 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by
scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
~
CANCEL
DEFAULT
0001 = Length 1 is 1 Character