Enter/Exit Programming Mode
202 QuickScan™ I QD24XX/QBT24XX/QM24XX
QR Code
Set Length 2
This feature specifies one of the bar code lengths for QR Code Length Control on page 200.
Length 2 is the maximum label length if in Variable Length Mode, or the second fixed length if
in Fixed Length Mode.
Characters can be set from 0001 to 7,089 characters in increments of
0001 (pad with zeroes).
See page 243 for detailed instructions on setting this feature.
Select QR Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code
at
left followed by the digits from the Alphanumeric
characters in
Appendix D, Keypad representing
your desired character(s). End by
scanning the ENTER/
EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort and
not save the entry string. You can then start again at the
beginning.
CANCEL
DEFAULT
Length 2 is 7,089 Characters
To Next Page
Loading...
