Deif GC-1F - Page 90

GC-1F Installation Instructions and Reference Handbook
DEIF A/S Page 90 of 123
6021…6025 Nominal settings 3 (1 ph) 6960 Parameter group 2
6031…6035 Nominal settings 4 (2ph) 6970 Parameter group 3
6041 Transformer U pri. Gen. 6980 Sleep mode settings
6042 Transformer U sec. Gen. 7040 AMF test function
6043 Transformer I pri. Gen. 7060-7110 Mains settings
6044 Transformer I sec. Gen. 7090 Island test function
6050 Transformer mains 7510-7520 Modbus comm. settings
6080 Language 7570-7660 EIC alarms configuration
6101 Running time 7940+7980 CAN 2 settings
6160 Run status 7950 KL320x config.
6171 Tacho – teeth 9116 Password – customer
6173 Tacho – run set point 9117 Password – service
6191 Start attempts 10000 Cmd.1 Tim/start/stop
6213 Cool-down temperature 10010 Cmd.1 Days(S)
6214 Cool-down reference 10020 Cmd.1 Hour(S)
6230 GB close delay 10030 Cmd.1 Minute(S)
6290 Idle mode 10040…10310 Cmd.2…..Cmd.8
Parameters only configurable from USW
10320-10370 GSM pin code and numbers
6320 Engine heater ON 10470-10610 Fuel level config. sensor
6330 Engine heater OFF 10640-10780 Oil pressure config. sensor
6560 Cool-down timeout 10810-10950 Water temp. config sensor
6570 Oil pres. RUN detect 10970 Unit settings
6700 Diode compensation 10980 Multi-input 1 selection (VDO/mA/Bin)
6940 Alarm LED function 10990 Multi-input 2 selection (VDO/mA/Bin)
6950 Parameter group 1 11000 Multi-input 3 selection (VDO/mA/Bin)