V0505, 3.8
3.d
If you press ‘gauge func’ a window appears with three programmable parameters.
3.e
Gauge pos.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GP
With this function you can program another ‘gauge position’ for this specific bend. The
gauge position (parameter GP) you can program depends on the backgauge dimensions.
Backgauge dimensions are programmed in the menu ‘program constants’.
Default gauge position = 0 (no lay on)
Other possibilities are:
gauge position = 1, lay on first level
gauge position = 2, lay on second level (only possible when number of gauge positions
To Next Page
Loading...
