Removing the front bezel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow the steps
in Before working inside your computer. After working inside your computer, follow the instructions in After working inside your
computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
Topics:
• Prerequisites
• Procedure
Prerequisites
1. Remove the stability foot.
2. Remove the left and right side-panels. See “
Removing the side panels”.
3. Remove the handle bars.
Procedure
1. Remove the four screws (#6-32x6) that secure the front bezel to the bottom and top of the chassis.
a. screws (4)
b. front bezel
2. Remove the two screws (6-32x5.2) from inside, securing the front bezel to the left side of the chassis.
3. Remove the screw (6-32x5.2) from inside, securing the front bezel to the right side of the chassis.
4. Release the tabs from inside the chassis on the right side, securing the front bezel to the chassis.
96
To Next Page
Loading...
