Replacing the stand
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
NOTE: The following procedure applies only to computers that are shipped with an articulating stand.
Align the tabs on the stand with the slots on the back cover and snap the stand into place on the back cover.
Procedure
NOTE
: The following procedure applies only to computers that are shipped with a pedestal stand.
1 Align the tabs on the stand with the slots on the back cover, slide the stand into the slots, and then snap it into place.
2 Replace the two screws (M3x5) that secure the stand to the back cover.
5
Replacing the stand 19
To Next Page
Loading...
