Replacing the antennas
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 At an angle, slide and align the antenna modules (2) with the slots on the middle frame and adhere them into place.
2 Adhere the tape that secures the antenna modules (2) to the display-assembly base.
3 Replace the two screws (M2x2.5) that secure the antenna modules (2) to the middle frame.
4 Route the antenna cables through the routing guides on the display-assembly base.
Post-requisites
1 Replace the speakers.
2 Replace the rear-I/O bracket.
3 Replace the base cover.
4 Replace the wireless card.
5 Replace the system-board shield.
6 Replace the back cover.
7 Replace the stand.
43
Replacing the antennas 69
To Next Page
Loading...
