Removing the display-assembly base
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the stand.
2 Remove the back cover.
3 Remove the hard drive.
4 Remove the system-board shield.
5 Remove the wireless card.
6 Remove the fan.
7 Remove the heat sink.
8 Remove the camera.
9 Remove the base cover.
10 Remove the rear-I/O bracket.
11 Remove the microphones.
12 Remove the speakers.
13 Remove the power-button board.
14 Remove the I/O board.
15 Remove the headset port.
16 Remove the antennas.
17 Remove the system board.
18 Remove the power-adapter port. (applicable on computers with FHD displays)
19 Remove the display panel.
20 Remove the middle frame.
Procedure
After performing the pre-requisites, you are left with the display-assembly base.
54
92 Removing the display-assembly base
To Next Page
Loading...
