Dell Inspiron 27 7000 All-in-One - 29 Replacing the Base Cover; Procedure; Post-Requisites

Replacing the base cover
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 At an angle, slide the tabs on the base cover under the slots on the middle frame.
2 Press the base cover down until it snaps into place on the middle frame.
3 Replace the two screws (M3x5) that secure the base cover to the display-assembly base and the two screws (M3x5) that secure the
base cover to the rear-I/O bracket.
Post-requisites
1 Replace the back cover.
2 Replace the stand.
29
Replacing the base cover 53