Dell Inspiron 27 7000 All-in-One - 48 Removing the Power-Adapter Port; Prerequisites; Procedure

Removing the power-adapter port
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the stand.
2 Remove the back cover.
3 Remove the hard drive.
4 Remove the system-board shield.
5 Remove the wireless card.
6 Remove the heat sink.
7 Remove the base cover.
8 Remove the rear-I/O bracket.
9 Remove the system board.
Procedure
NOTE
: The following procedure only applies to computers shipped with Full High Denition (FHD) displays.
1 Remove the power-adapter port cable through the routing guides on the display-assembly base.
2 Remove the two screws (M3x5) that secure the power-adapter port to the display-assembly base.
3 Lift the power-adapter port, along with its cable, o the display-assembly base.
48
80 Removing the power-adapter port