Dell Inspiron 27 7000 All-in-One - 26 Removing the Camera; Prerequisites; Procedure

Removing the camera
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
1 Remove the stand.
2 Remove the back cover.
3 Remove the system-board shield.
Procedure
NOTE
: The size and conguration of the camera module may vary depending on the conguration ordered.
1 Disconnect the camera cable from the system board.
2 Remove the two screws (M3x5) that secure the retractable-camera assembly door to the middle frame.
3 Lift the retractable-camera assembly door out of the middle frame
4 Remove the two screws (M3x5) that secure the retractable-camera assembly to the display-assembly base.
5 Slide and lift the retractable-camera assembly out of the display-assembly base.
6 Press the top of the retractable-camera assembly to extend the retractable camera.
26
Removing the camera 47