Dell Inspiron 27 7000 All-in-One - 11 Replacing the Memory Module; Procedure

Replacing the memory module
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Align the notch on the memory module with the tab on the memory-module slot.
2 Slide the memory module rmly into the slot at an angle.
3 Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
NOTE: Repeat this procedure for each memory module shipped with your computer.
4 Align the tabs on the DIMM door with the slots on the system-board shield and snap it into place.
NOTE
: If you do not hear the click, remove the DIMM door and realign it.
11
28 Replacing the memory module