Replacing the display panel
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
NOTE: The touchscreen cable is only present in computers shipped with touchscreen displays.
1 Place the display-assembly base in its upright position, and slide the display panel into the slot between the middle frame and the
display-assembly base.
2 Push the display cable, touchscreen cable, and display-backlight cable through the slots on the display-assembly base.
3 Push the display panel towards the display-assembly base, closing the gap between the display panel and the middle frame.
NOTE
: Ensure the display cable, touchscreen cable, and display-backlight cable has been fully threaded through the slots on
the display-assembly base before closing the gap between the display panel and the middle frame.
4 Place the display-assembly base on a clean and at surface with the display panel facing down and screw in the jig screw in the
location shown.
NOTE
: For proper gap alignment of the display panel and the middle frame, ensure that this step is completed before
replacing the screws.
51
84 Replacing the display panel
To Next Page
Loading...
