Figure 71. Installing the processor fan and heat-sink assembly (for 65 W processors)
Steps
1. Align the screw holes on the processor fan and heat-sink assembly with the screw holes on the system board.
2. Place the processor fan and heat-sink assembly on the processor.
3. In the sequential order (1 > 2 > 3 > 4) etched on the system board, tighten the four captive screws to secure the processor
fan and heat-sink assembly to the system board.
4. Connect the processor fan and heat-sink assembly cable to the connector (FAN CPU) on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Removing the processor fan and heat-sink assembly (for 125 W
processors)
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
100
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
