Optional DisplayPort module
Removing the optional DisplayPort module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the optional DisplayPort module and provide a visual representation of the removal
procedure.
Figure 90. Removing the optional DisplayPort module
Steps
1. Remove the two screws (M3X3) that secure the optional DisplayPort module to the chassis.
2. Disconnect the optional DisplayPort-module cable from the connector (VIDEO) on the system board.
3. Lift the optional DisplayPort module off the system board.
Installing the optional DisplayPort module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional DisplayPort module and provide a visual representation of the
installation procedure.
Removing and installing Field Replaceable Units (FRUs)
119
To Next Page
Loading...
