4. Align and slide the PCIe blanking plate in the slot on the chassis.
NOTE: Do not perform this step if you are immediately replacing the graphics card with a new PCIe card.
5. Close the PCIe door and press it gently until it clicks in place on the chassis.
NOTE: Do not perform this step if you are immediately replacing the graphics card with a new PCIe card.
Installing the graphics card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the graphics card and provide a visual representation of the installation procedure.
Figure 27. Installing the graphics card
Removing and installing Customer Replaceable Units (CRUs)
55
To Next Page
Loading...
