Figure 10. Removing the side cover
Steps
1. Slide the release latch downwards to release the side cover from the chassis.
2. Slide the side cover outwards, towards the rear of the computer, and lift the side cover away from the chassis.
3. Place the computer on its side with the side-cover opening facing up.
NOTE: This step applies only if you are replacing any component other than the front bezel.
Installing the side cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the side cover and provides a visual representation of the installation procedure.
38
Removing and installing side cover
To Next Page
Loading...
