Figure 84. Removing the optional serial module
Steps
1. Remove the two screws (M3) that secure the optional serial module to the chassis.
2. Disconnect the optional serial module cable from the connector (KB MS SERIAL) on the system board.
3. Slide the optional serial module out of the port opening and lift the optional serial module off the system board.
Installing the optional serial module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional serial module and provide a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
113
To Next Page
Loading...
