NOTE: This step applies only if you are replacing a M.2 2230 solid-state drive with a M.2 2280 solid-state drive.
2. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot (M.2 PCIe SSD-0, M.2 PCIe SSD-1 or
M.2 PCIe SSD-2, whichever is applicable) on the system board.
3. At an angle, slide and place the M.2 2280 solid-state drive in the M.2 card slot on the system board.
4. Replace the screw (M2x3.5) to secure the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
External puck antenna
Computers that are shipped with Intel Wi-Fi 6E AX211 wireless card come with an external puck antenna installed.
For more information about the installation procedure of external puck antenna for your computer, see OptiPlex Antenna
Installation Guide on the documentation support page of OptiPlex Tower Plus 7020.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the wireless card and provide a visual representation of the removal procedure.
Removing and installing Customer Replaceable Units (CRUs)
51
To Next Page
Loading...
