Figure 93. Installing the optional VGA module
Steps
1. Using a screwdriver, remove the optional-module cover from the chassis.
NOTE: This step is applicable only when the optional VGA module is being installed for the first time.
NOTE: To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to
release it, and then lift the cover off the chassis.
2. Insert the optional VGA module in the slot on the chassis.
3. Connect the VGA module cable to the connector (VIDEO) on the system board .
4. Replace the two screws (M3) to secure the optional VGA module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Optional USB Type-C module
Removing the optional USB Type-C module
CAUTION: The information in this removal section is intended for authorized service technicians only.
122 Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
