Installing the optional PS2 and serial module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the PS2 and serial module and provide a visual representation of the installation
procedure.
Figure 87. Installing the optional PS2 and serial module
Steps
1. Lift the pull tab on the PCIe door outwards to open the PCIe door.
2. Remove the PCIe blanking plate from the slot on the chassis.
NOTE: Ensure to keep the PCIe blanking plate safe for future use.
3. Align and place the PS2 and serial module in the PCIe slot on the chassis.
4. Route the PS2 and serial module cable through the routing guides on the chassis.
116
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
