Figure 24. Removing the wireless card
Steps
1. Remove the screw (M2x3.5) that secures the wireless-card bracket to the system board.
2. Slide and lift the wireless-card bracket off the wireless card.
3. Disconnect the antenna cables from the connectors on the wireless card.
4. Slide and lift the wireless card off the wireless-card slot (M.2 WLAN) on the system board.
Installing the wireless card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the wireless card and provide a visual representation of the installation procedure.
52
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
