Figure 85. Installing the optional serial module
Steps
1. Using a screwdriver, remove the optional-module cover from the chassis.
NOTE: This step is applicable only when the optional serial module is being installed for the first time.
NOTE: To remove the optional-module cover, insert a flat-head screwdriver in the hole of the cover, push the cover to
release it, and then lift the cover off the chassis.
2. Insert the optional serial module in the slot on the chassis.
3. Connect the serial-module cable to the connector (KB MS SERIAL) on the system board
4. Replace the two screws (M3) to secure the optional serial module to the chassis.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Optional PS2 and serial module
Removing the optional PS2 and serial module
Prerequisites
1. Follow the procedure in Before working inside your computer.
114
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
