Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the optional USB Type-C module and provide a visual representation of the
removal procedure.
Figure 94. Removing the optional USB Type-C module
Steps
1. Remove the two screws (M3x3) that secure the optional USB Type-C module to the chassis.
2. Disconnect the optional USB Type-C-module cables from the connectors (VIDEO and TYPE-C) on the system board.
3. Lift the optional USB Type-C module off the system board.
Installing the optional USB Type-C module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional USB Type-C module and provide a visual representation of the
installation procedure.
Removing and installing Field Replaceable Units (FRUs)
123
To Next Page
Loading...
