5. Connect the PS2 and serial module cable to the connector (KB MS SERIAL) on the system board.
6. Close the PCIe door and press it gently until it clicks in place on the chassis, to secure the PS2 and serial module.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Optional HDMI module
Removing the optional HDMI module
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the optional HDMI module and provide a visual representation of the removal
procedure.
Figure 88. Removing the optional HDMI module
Steps
1. Remove the two screws (M3X3) that secure the optional HDMI module to the chassis.
2. Disconnect the optional HDMI-module cable from the connector (VIDEO) on the system board.
3. Lift the optional HDMI module off the system board.
Installing the optional HDMI module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Removing and installing Field Replaceable Units (FRUs) 117
To Next Page
Loading...
