2. Align the screw holes on the 3.5-inch hard-drive bracket to the holes on the hard drive.
3. Replace the fours screws (#6-32) to secure the secondary 3.5-inch hard-drive to the hard-drive bracket.
4. Align and place the secondary 3.5-inch hard-drive assembly in the hard-drive slot on the chassis.
5. Replace the screw (#6-32) to secure the secondary 3.5-inch hard-drive assembly to the chassis.
6. Connect the data and power cables to the respective connectors on the secondary 3.5-inch hard drive.
7. Route the data and power cables through the retention clips on the secondary 3.5-inch hard drive assembly.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
Optical drive
Removing the slim optical drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
About this task
The following images indicate the location of the slim optical drive and provide a visual representation of the removal procedure.
72
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
