Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the system fan and provide a visual representation of the removal procedure.
Figure 78. Removing the system fan
Steps
1. Disconnect the system-fan cable from the connector (FAN SYS) on the system board.
2. Gently pull and release the system fan from the rubber grommets.
3. Remove the system fan from the chassis.
Installing the system fan
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
107
To Next Page
Loading...
