3. Remove the front bezel.
About this task
The following images indicate the location of the media-card reader and provide a visual representation of the removal
procedure.
Figure 32. Removing the media-card reader
Steps
1. Remove the screw (M3x3) that secures the media-card reader door to the chassis.
2. Lift to open the media-card reader door and remove it from the chassis.
3. Remove the screw (M2x3.5) that secures the media-card reader to the system board.
4. Slide and remove the media-card reader from the connector (SD CARD) on the system board.
Installing the media-card reader
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing Customer Replaceable Units (CRUs)
61
To Next Page
Loading...
