About this task
The following images indicate the location of the media-card reader and provide a visual representation of the installation
procedure.
Figure 33. Installing the media-card reader
Steps
1. Connect the media-card reader to the connector (SD CARD) on the system board.
2. Replace the screw (M2x3.5) to secure the media-card reader to the system board.
3. Align and insert the tabs on the media-card reader door in the slots on the chassis.
4. Close the media-card reader door.
5. Replace the screw (M3x3) to secure the media-card door bracket to the chassis.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in After working inside your computer.
62
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
