Figure 51. Installing the internal speaker
Steps
1. Press the tab on the internal speaker, align and slide the internal speaker in the slot on the chassis until it snaps in place.
NOTE: Ensure that the internal speaker is secured under the tabs on the chassis.
2. Open the retention clip, route the internal-speaker cable through the retention clip and close the clip to secure the cable.
3. Connect the internal-speaker cable to the connector (INT SPKR) on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Expansion card
Removing the network card
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the network card and provide a visual representation of the removal procedure.
80
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
