Figure 75. Removing the power-supply unit
Steps
1. Disconnect the power-supply unit cables from the connectors (ATX CPU1, ATX CPU2, and ATX SYS) on the system board.
2. Open the retention clips that secure the power-supply unit cables to the chassis.
3. Remove the power-supply unit cables from the routing guides on the chassis.
4. Remove the three screws (#6-32) that secure the power-supply unit to the chassis.
5. Slide and lift the power-supply unit off the chassis.
Installing the power-supply unit
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the installation
procedure.
104
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
