Installing the intrusion switch
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the intrusion switch and provide a visual representation of the installation
procedure.
Figure 59. Installing the intrusion switch
Steps
1. Insert the intrusion switch in the slot on the chassis and slide the intrusion switch to the locked position to secure it to the
chassis.
2. Connect the intrusion-switch cable to the connector (INTRUSION) on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
Removing and installing Customer Replaceable Units (CRUs)
87
To Next Page
Loading...
