● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, and the quantity of screws,
and then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 27. Screw list
Component Screw type Quantity Screw image
M.2 2230/2280 solid-state
drive
M2x3.5 1
Wireless card M2x3.5 1
Secondary 3.5-inch hard drive #6-32 5
Media-card reader door M3x3 1
Media-card reader (optional) M2x3.5 1
Disk-drive cage M3 1
Internal antenna module M3x3 2
Processor fan and heat-sink
assembly
Captive screw 4
Power-supply unit #6-32 3
Voltage-regulator heat sink Captive screw 4
Serial/VGA module (optional) M3 2
34 Working inside your computer
To Next Page
Loading...
