Figure 41. Removing the secondary 3.5-inch hard drive
Steps
1. Disconnect the data and power cables from the respective connectors on the secondary hard drive.
2. Remove the data and power cables from the retention clips on the secondary hard-drive assembly.
3. Remove the screw (#6-32) that secures the secondary 3.5-inch hard drive to the chassis.
4. Remove the secondary 3.5-inch hard-drive assembly from the chassis.
5. Remove the four screws (#6x32) that secure the secondary 3.5-inch hard drive to the hard-drive bracket.
6. Slide and remove the secondary 3.5-inch hard drive from the hard-drive bracket.
Installing the secondary 3.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the secondary 3.5-inch hard drive and provide a visual representation of the
installation procedure.
70
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
