Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the removal
procedure.
Figure 92. Removing the optional VGA module
Steps
1. Remove the two screws (M3) that secure the optional VGA module to the chassis.
2. Disconnect the optional VGA module cable from the connector (VIDEO) on the system board.
3. Slide the optional VGA module out of the port opening and lift the optional VGA module off the system board.
Installing the optional VGA module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the optional VGA module and provide a visual representation of the installation
procedure.
Removing and installing Field Replaceable Units (FRUs)
121
To Next Page
Loading...
