Figure 17. Installing the memory module
Steps
1. Ensure that the memory-module securing clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot (DIMM1, DIMM2, DIMM3 or DIMM4,
whichever is applicable) .
3. Press down on the memory module until the memory module snaps in position and the securing clips lock in place.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch
the components on the memory module.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
4. Repeat steps 1 to 3 to install the other memory modules in your computer, if applicable.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
M.2 solid state drive
M.2 2230 solid-state drive
Removing the M.2 2230 solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
46
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
