About this task
The following images indicate the location of the system fan and provide a visual representation of the installation procedure.
Figure 79. Installing the system fan
Steps
1. Ensure that the rubber gromments are installed in the computer chassis.
NOTE:
Align and insert the rubber grommets through the holes on the chassis to install the rubber gromments in the
computer chassis.
2. Align the holes on the system fan to the rubber grommets on the chassis.
3. Insert the rubber grommets through the holes on the system fan.
4. Pull the rubber grommets and push the system fan towards the chassis until it fits in place.
5. Connect the system-fan cable to the connector (FAN SYS) on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
108
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
