Dell OptiPlex Tower Plus 7020 - Page 48

Figure 19. Installing the M.2 2230 solid-state drive
Figure 20. Installing the M.2 2230 solid-state drive
Steps
1. Remove the standoff nut (M2) from the M.2 slot (2280) and place it on the M.2 slot (2230), at half length, on the system
board.
NOTE: This step applies only if you are replacing a M.2 2280 solid-state drive with a M.2 2230 solid-state drive.
2. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot (M.2 PCIe SSD-0, M.2 PCIe SSD-1 or
M.2 PCIe SSD-2, whichever is applicable) on the system board.
48
Removing and installing Customer Replaceable Units (CRUs)