Dell PowerEdge C6320 - Page 135

Figure 77. Removing and installing the midplane holder
1. screw (6) 2. midplane holder
13. Disconnect all the cables from the lower midplane.
Note the routing of the cable on the chassis as you remove them from the system. You must route
these cables properly when you replace them to prevent the cables from being pinched or crimped.
14. Remove the power cable cover from the lower midplane.
15. Remove the four power cables from the lower midplane.
16. Remove the screws that secure the lower midplane to the chassis.
17. Lift the lower midplane out of the chassis.
Figure 78. Removing and installing the lower midplane
1. screw (8) 2. lower midplane
135