System board assembly
Removing the system board assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
4. Disconnect all the external cables from the system board.
Steps
1. Remove the screw that secures the retaining latch.
2. Press the retaining latch and by using the handle, slide the system board assembly out of the chassis.
Figure 38. Removing and installing a system board assembly
1. retaining latch 2. screw
3. handle 4. system board assembly
Related Links
Safety instructions
Installing the system board assembly
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
88
To Next Page
Loading...
