Dell PowerEdge C6320 - Front Panel Features and Indicators

Keystroke Description
F2 Enters the System Setup program.
F11 Enters the BIOS Boot Manager.
F12 Starts Preboot eXecution Environment (PXE)/iSCSI boot.
Ctrl +C Enters the LSI 2008 SAS Mezzanine Card Configuration Utility. For more
information, see the SAS adapter documentation.
Ctrl+R Enters the PERC 9 Card Configuration Utility. For more information, see the
documentation for your SAS RAID card.
Ctrl+Y Enters the MegaPCLI SAS RAID Management Tool.
Ctrl+S Enters the utility to configure onboard LAN settings for PXE boot. For more
information, see the documentation for your integrated LAN.
Ctrl+I Enters onboard SATA Controller’s Configuration Utility.
Ctrl+D Enters the Intel iSCSI setup menu.
Front panel features and indicators
Figure 2. Front panel − 3.5-inch x12 hard drives with four system boards (C6320 RAID card and onboard SATA
controller)
Figure 3. Front panel − 2.5-inch x24 hard drives with four system boards (C6320 RAID card and onboard
SATA controller)
NOTE: For more information about the direction details of the 2.5-inch hard drive expander
configuration support, see the HDD Zoning configuration tool at Dell.com/support.
Table 1. Front panel features and indicators
Item Indicator, button or
connector
Icon Description
1
Power-on indicator or system
state indicator or power
button for system board 1
The power-on indicator turns to green when
the system power is on.
10