Dell PowerEdge R360 - Page 10

Table 3. Features available on the rear of the system(continued)
Item Ports, panels, or slots Icon Description
2 NIC ports The NIC ports that are
integrated on the system
board provide network
connectivity.
3 PCIe expansion riser card slot
1
N/A The expansion card riser
enables you to connect PCI
Express expansion cards.For
more information, see the
Expansion card installation
guidelines section.
4 PCIe expansion riser card slot
2
N/A The expansion card riser
enables you to connect PCI
Express expansion cards.For
more information, see the
Expansion card installation
guidelines section.
5 Power supply unit (PSU 1) Indicates the PSU.
6 Power supply unit (PSU 2) Indicates the PSU.
7 BOSS-N1 module N/A BOSS-N1 module for internal
system boot.
8 System Identification (ID)
button
The System Identification (ID)
button is available on the
front and back of the system.
Press the button to identify
a system in a rack by turning
on the system ID button. You
can also use the system ID
button to reset iDRAC and to
access BIOS using the step
through mode. When pressed,
the system ID LED in the back
panel blinks until either the
front or rear button is pressed
again. Press the button to
toggle between on or off
mode.
NOTE: If the server
stops responding during
POST, press and hold the
System ID button for
more than five seconds to
enter the BIOS progress
mode
NOTE: To reset the
iDRAC (if not disabled on
the iDRAC setup page by
pressing F2 during system
boot), press and hold the
System ID button for
more than 15 seconds.
9 USB 3.2 Gen1 port This port is USB 3.2 Gen1-
compliant.
10 PowerEdge R360 system overview