Dell PowerEdge R360 - Removing the Processor; Installing the Processor

Next steps
If you are removing a faulty heat sink install the heatsink, if not remove the processor.
Removing the processor
Prerequisites
WARNING: Remove the processor from processor and heat sink module (PHM) only if you are replacing the
processor or heat sink.
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in the Before working inside your system.
3. Remove air shroud.
4. Remove the heatsink.
CAUTION: You may find the CMOS battery loss or CMOS checksum error that is displayed during the first
instance of powering on the system after the processor or system board replacement which is expected. To fix
this, simply go to setup option to configure the system settings.
Steps
1. Release the socket lever by pushing the lever down and then out from under the tab on the processor shield.
2. Lift the lever upward until the processor shield lifts.
CAUTION:
The processor socket pins are fragile and can be permanently damaged. Be careful not to bend the
pins in the processor socket when removing the processor out of the socket.
3. Holding the processor by the edges, lift the processor out of the socket.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 45. Removing the processor
Next steps
Install the processor.
Installing the processor
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove air shroud.
4. Remove the heatsink.
78
Installing and removing system components